| 1. Substitute a vessel under a drain stopper of a radiator. |
|
|
2. Two flat-nose pliers turn off a drain stopper and a stopper of a mouth of a radiator (press and turn against a chasosy arrow). Merge liquid. Then turn off a stopper and merge liquid from the block of cylinders (if liquid does not pour down, punch the screw-driver a rust in a drain opening). |
| 3. Check and if necessary replace the damaged cooling system hoses. |
| 4. Wash out a radiator a pure stream (deletes only a deposit), if necessary wash out special detergent (deletes stratifications of a rust). If it is not possible to wash out a radiator or if there are noticeable damages and a leak, remove a radiator and take to repare. |
| 5. Disconnect a tank hose, merge liquid, wash out a tank and dress a hose. |
| 6. Tighten both drain stoppers. |
| 7. Transfer a heater rychazhok to the provision of the maximum thermolysis. |
| 8. Fill in liquid (in the ratio 50/50 waters and antifreeze) to the lower mark of a tank. |
| 9. Without closing a stopper a radiator, warm up the engine before opening of the thermostat (it is felt on heating of the top hose). |
| 10. Stop the engine and after cooling fill in liquid to edge of a mouth, having pressed on a hose, remove air then wrap a stopper. |
|
11. Start the engine and be convinced of lack of a leak. |
