Toyota Land Cruiser
FJ60, FJ62 and FJ80 1980-1997 of release
Repair and operation of the car
Toyota Land Cruiser
+ 1. Maintenance instruction
- 2. Maintenance
2.1. Additional maintenance
2.2. Technical characteristics
2.3. An arrangement of units in a motor compartment
2.4. Maintenance terms
+ 2.5. Check of level of liquids
2.6. Check of a condition of tires and pressure in tires
2.7. Liquid level in automatic transmission
2.8. Liquid level in system of a hydraulic actuator of steering
2.9. Replacement of oil in the engine and an oil filter
2.10. Check of a state and care of the battery
2.11. Check of the cooling system
2.12. Check and replacement of hoses in a motor compartment
2.13. Check and replacement of brushes of screenwash
2.14. Shift of wheels
2.15. Check of a suspension bracket and steering
2.16. Check of the exhaust system
2.17. Check of level of oil in the manual transmission
2.18. Check of level of oil in the transfer case
2.19. Check of level of oil in reducers of bridges
2.20. Check of a condition of seat belts
2.21. Thermostat of the air filter (carburetor engines)
2.22. Check and lubricant of the exhaust valve
2.23. System of catching of vapors of gasoline
2.24. Check of system of recirculation
2.25. Air gate of the carburetor
2.26. Zolotnik of system of ventilation of a case
2.27. Check and replacement of the air filter
2.28. Replacement of spark plugs
2.29. Check and adjustment of gaps of valves
2.30. Idling turns (carburetor engines)
2.31. Drive belts
2.32. Check of fuel system
+ 2.33. Check of brakes
2.34. Check and adjustment of pedals of coupling (brake)
2.35. Replacement of the fuel filter
2.36. High-voltage wires, runner and covers of the distributor
2.37. Check and installation of the moment of ignition
2.38. Care of the cooling system
2.39. Naves and bearings of forward wheels
2.40. Replacement of liquid in automatic transmission and the filter
2.41. Replacement of oil in the manual transmission
2.42. Replacement of oil in the transfer case
2.43. Replacement of oil in a back (forward) reducer
2.44. Gaps in valves on the engine 1FZ-FE
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries
In this manual the term "maintenance" belongs to set of the performed works, but not to the concrete procedure. If from the moment of acquisition of the new car in accuracy to observe a maintenance order, to carry out frequent inspections of level of liquids and details subject to the increased wear, then at the engine high operational qualities will remain and the volume of additional works will be minimized.
Irregular maintenance can become the main reason for abnormal operation of the engine. Especially it concerns the engine of the acquired not new car which was not exposed to regular checks. In such cases besides periodic maintenance, it is necessary to perform additional adjustment works.
Any kind of works on maintenance, or search of the reason of abnormal operation of the engine should be begun with check of a compression in cylinders. Check of a compression in cylinders gives valuable information of rather general condition of many details of the internal device of the engine which can be used as fundamental both for the current maintenance, and for repair procedures. If, for example, a compression such is that strong wear of the engine is obvious, then routine maintenance will not lead to restoration of normal operational qualities and all works come down to an excessive waste of time and money.
The list of works which performance often leads to recovery of normal operation of the engine is given below.
Minor adjustment works
Check a state and level of all liquids of the engine.
Clear, examine and check the rechargeable battery.
Check the cooling system.
Check all hoses in a motor compartment.
Check a condition of a zolotnik of ventilation of a case.
Check a condition of the air filter and filter of ventilation of a case.
Replace spark plugs.
Check high-voltage wires, a cover and the runner of the distributor of ignition.
Check and adjust gaps in valves.
Check and adjust turns of idling and the moment of ignition.
Check a state drive belts.
Main adjustment works
Perform all minor works and those which are listed below:
Check system of recirculation.
Replace a zolotnik of ventilation of a case.
Replace the air filter and the filter of ventilation of a case.
Check fuel system.
Replace the fuel filter.
Replace wires, a cover and the runner of the distributor of ignition.
Check system of ignition.
Check system of a charge of the battery.