Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and operation of the car

Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   - 3.1. Engines 2F and 3F-E
      3.1.1. Technical characteristics
      3.1.2. Types of repair without dismantle of the engine
      3.1.3. Installation of the piston of the 1st cylinder in VMT
      3.1.4. Cover of a head of cylinders
      3.1.5. Side cover of the mechanism of gas distribution
      3.1.6. Yokes and bars of pushers
      3.1.7. Springs of valves, plates, oil scraper caps
      3.1.8. The soaking-up and final collectors
      3.1.9. Head of cylinders
      3.1.10. Pushers
      3.1.11. Crankshaft pulley
      3.1.12. Forward epiploon of the crankshaft
      3.1.13. Forward cover
      3.1.14. Cam-shaft and gear wheels of the drive
      3.1.15. Cam-shaft and support
      3.1.16. Replacement of bearings
      3.1.17. Oil pallet
      3.1.18. Oil pump
      3.1.19. Flywheel (drive plate of the hydrotransformer)
      3.1.20. Back epiploon of the crankshaft
      3.1.21. Details of a suspension bracket and engine
   + 3.2. Verkhneklapanny engine 1FZ-FE
   + 3.3. Dismantle and capital repairs of the engine
   + 3.4. Engine electric equipment
+ 4. Cooling systems, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries

3.1.6. Yokes and bars of pushers

Removal

PERFORMANCE ORDER

1. Uncover a head of cylinders.
	2. Release bolts of the roller of yokes in the specified sequence.
3. Remove the roller assembled with yokes, without allowing sliding of details.

4. Get bars (the drawing at the left) and you store in an order of their former installation (a photo on the right).

Check

PERFORMANCE ORDER

1. Check wear of yokes, especially in places of contact with bars and midstreams of valves.

2. Check purity of openings of yokes in the place of contact with bars.

3. Check existence of cracks, navolakivaniye of metal and wear tracks about a yoke opening under the roller. Replace worn-out yokes.

4. Check a condition of bars, existence of cracks and strong wear of end faces, check наощупь deformation of bars, having given a ride to them on sheet glass.

Installation

PERFORMANCE ORDER

1. Oil the lower end faces of bars for the engine or molybdenic lubricant and establish bars on the places. The bar has to enter deepening of a pusher.
2. Grease with molybdenic lubricant the top end faces of bars and cores of valves.
	3. Install rollers with yokes and covers, screw hairpins of a cover of a head of cylinders. Tighten bolts in the specified sequence.
4. Establish all removed details, start the engine and listen to operation of the valvate mechanism.