Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and operation of the car



Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   - 3.1. Engines 2F and 3F-E
      3.1.1. Technical characteristics
      3.1.2. Types of repair without dismantle of the engine
      3.1.3. Installation of the piston of the 1st cylinder in VMT
      3.1.4. Cover of a head of cylinders
      3.1.5. Side cover of the mechanism of gas distribution
      3.1.6. Yokes and bars of pushers
      3.1.7. Springs of valves, plates, oil scraper caps
      3.1.8. The soaking-up and final collectors
      3.1.9. Head of cylinders
      3.1.10. Pushers
      3.1.11. Crankshaft pulley
      3.1.12. Forward epiploon of the crankshaft
      3.1.13. Forward cover
      3.1.14. Cam-shaft and gear wheels of the drive
      3.1.15. Cam-shaft and support
      3.1.16. Replacement of bearings
      3.1.17. Oil pallet
      3.1.18. Oil pump
      3.1.19. Flywheel (drive plate of the hydrotransformer)
      3.1.20. Back epiploon of the crankshaft
      3.1.21. Details of a suspension bracket and engine
   + 3.2. Verkhneklapanny engine 1FZ-FE
   + 3.3. Dismantle and capital repairs of the engine
   + 3.4. Engine electric equipment
+ 4. Cooling systems, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries




Soap2day eeac64fe


3.1.19. Flywheel (drive plate of the hydrotransformer)

Removal

PERFORMANCE ORDER
1. Lift the car and establish on supports. Remove transmission (check point).
2. Check and if necessary replace a check point epiploon (a sealing ring on automatic transmission).
3. Remove coupling (on the manual transmission).
4. Designate tags the provision of a flywheel concerning the crankshaft.
5. Turn off flywheel bolts (a drive plate of the hydrotransformer). Record a flywheel from a provorachivaniye, having rested the screw-driver against a gear wreath.
6. Carefully remove a flywheel (a drive plate of the hydrotransformer).

Installation

PERFORMANCE ORDER
1. Clear a flywheel, check existence for surfaces of traces of deep development, furrows from rivets, traces of burning out and scratches. Insignificant damages can be eliminated with cleaning by a skin. Check deformation of the plane of a flywheel.
2. Clear and check a condition of the plane of the socket of a flywheel and the crankshaft. If it is revealed that the back epiploon of the crankshaft leaks, then before establishing a flywheel (a drive plate of the hydrotransformer), replace an epiploon.
3. Install a flywheel (a drive plate of the hydrotransformer) on the crankshaft. Combine the tags put at removal. Before a wraparound of bolts grease carvings with the fixing structure. On a part of cars the flywheel is established on pins.
4. Record a flywheel the screw-driver for a gear wreath and tighten fastening bolts with the set moment. Tighten opposite bolts.
5. Further assembly is carried out upside-down.