Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and operation of the car



Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   - 3.1. Engines 2F and 3F-E
      3.1.1. Technical characteristics
      3.1.2. Types of repair without dismantle of the engine
      3.1.3. Installation of the piston of the 1st cylinder in VMT
      3.1.4. Cover of a head of cylinders
      3.1.5. Side cover of the mechanism of gas distribution
      3.1.6. Yokes and bars of pushers
      3.1.7. Springs of valves, plates, oil scraper caps
      3.1.8. The soaking-up and final collectors
      3.1.9. Head of cylinders
      3.1.10. Pushers
      3.1.11. Crankshaft pulley
      3.1.12. Forward epiploon of the crankshaft
      3.1.13. Forward cover
      3.1.14. Cam-shaft and gear wheels of the drive
      3.1.15. Cam-shaft and support
      3.1.16. Replacement of bearings
      3.1.17. Oil pallet
      3.1.18. Oil pump
      3.1.19. Flywheel (drive plate of the hydrotransformer)
      3.1.20. Back epiploon of the crankshaft
      3.1.21. Details of a suspension bracket and engine
   + 3.2. Verkhneklapanny engine 1FZ-FE
   + 3.3. Dismantle and capital repairs of the engine
   + 3.4. Engine electric equipment
+ 4. Cooling systems, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries



3.1.12. Forward epiploon of the crankshaft

GENERAL INFORMATION

Prevention

The epiploon can be replaced without removal of a forward cover. However access to an epiploon extends and it is more convenient to work if to uncover.


Replacement of an epiploon without removal of a forward cover

PERFORMANCE ORDER
1. Disconnect the battery from weight. Remove a crankshaft pulley (see subsection 3.1.11).
2. Remember orientation of an epiploon and having hooked, take an epiploon.
3. Slightly grease an external surface and working edges of a new epiploon with oil for the engine and press a new epiploon without distortions by means of a mandrel with a diameter a little smaller what diameter of an epiploon. The forward surface of an epiploon has to be aflush with a forward cover.
4. Establish a pulley.

Replacement of an epiploon with removal of a cover

PERFORMANCE ORDER
1. Remove a forward cover.
2. Hook and get an epiploon. At a considerable run of the engine fill in the getting liquid in a gap between an epiploon and the case and wait time sufficient for impregnation.
3. Clear an opening under an epiploon and slightly grease an external surface and working edges of a new epiploon with oil for the engine.
4. Carefully without distortions press a new epiploon into place by means of a mandrel with a diameter a little smaller what diameter of an epiploon (a photo at the left) or blows through whetstone (a photo on the right).
5. Establish other details upside-down.