Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and operation of the car



Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   - 3.1. Engines 2F and 3F-E
      3.1.1. Technical characteristics
      3.1.2. Types of repair without dismantle of the engine
      3.1.3. Installation of the piston of the 1st cylinder in VMT
      3.1.4. Cover of a head of cylinders
      3.1.5. Side cover of the mechanism of gas distribution
      3.1.6. Yokes and bars of pushers
      3.1.7. Springs of valves, plates, oil scraper caps
      3.1.8. The soaking-up and final collectors
      3.1.9. Head of cylinders
      3.1.10. Pushers
      3.1.11. Crankshaft pulley
      3.1.12. Forward epiploon of the crankshaft
      3.1.13. Forward cover
      3.1.14. Cam-shaft and gear wheels of the drive
      3.1.15. Cam-shaft and support
      3.1.16. Replacement of bearings
      3.1.17. Oil pallet
      3.1.18. Oil pump
      3.1.19. Flywheel (drive plate of the hydrotransformer)
      3.1.20. Back epiploon of the crankshaft
      3.1.21. Details of a suspension bracket and engine
   + 3.2. Verkhneklapanny engine 1FZ-FE
   + 3.3. Dismantle and capital repairs of the engine
   + 3.4. Engine electric equipment
+ 4. Cooling systems, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries



3.1.13. Forward cover

Removal

PERFORMANCE ORDER
1. Remove a crankshaft pulley.
2. Remove the fan (see subsection 4.4).
3. Remove the compressor of the conditioner and an arm with the generator, take aside.
4. Turn off bolts of fastening of a cover.
5. Carefully uncover the engine.

Installation

PERFORMANCE ORDER
1. Remove the remains of consolidation and replace an epiploon.
2. Apply sealant on the cover plane, establish a cover and wrap bolts.
3. Wrap two lower bolts on sealant. In the drawing designation of bolts of a forward cover on the engine 3F-E is given (see subsection 3.1.1). Grease carvings of bolts And sealant.
4. Establish a crankshaft pulley.
5. Tighten cover bolts.
6. Establish other details upside-down. Start the engine and be convinced of lack of a leak.