Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and operation of the car



Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   - 3.1. Engines 2F and 3F-E
      3.1.1. Technical characteristics
      3.1.2. Types of repair without dismantle of the engine
      3.1.3. Installation of the piston of the 1st cylinder in VMT
      3.1.4. Cover of a head of cylinders
      3.1.5. Side cover of the mechanism of gas distribution
      3.1.6. Yokes and bars of pushers
      3.1.7. Springs of valves, plates, oil scraper caps
      3.1.8. The soaking-up and final collectors
      3.1.9. Head of cylinders
      3.1.10. Pushers
      3.1.11. Crankshaft pulley
      3.1.12. Forward epiploon of the crankshaft
      3.1.13. Forward cover
      3.1.14. Cam-shaft and gear wheels of the drive
      3.1.15. Cam-shaft and support
      3.1.16. Replacement of bearings
      3.1.17. Oil pallet
      3.1.18. Oil pump
      3.1.19. Flywheel (drive plate of the hydrotransformer)
      3.1.20. Back epiploon of the crankshaft
      3.1.21. Details of a suspension bracket and engine
   + 3.2. Verkhneklapanny engine 1FZ-FE
   + 3.3. Dismantle and capital repairs of the engine
   + 3.4. Engine electric equipment
+ 4. Cooling systems, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries




eeac64fe


3.1.17. Oil pallet

GENERAL INFORMATION

Oil pallet of the engine 3F-E

1. Oil pump
2. The roller of the conducted gear wheel
3. Leading gear wheel
4. The conducted gear wheel
5. Oil receiver
6. Reducing valve
7. Spring
8. Cap
9. Oil pallet
10. Drain stopper
11. Laying
12. Final branch pipe
13. Roller of the leading gear wheel

Removal

PERFORMANCE ORDER
1. Disconnect the battery from weight.
2. Lift a car front.
3. Merge oil and remove an oil filter.
4. Disconnect an exhaust pipe from a collector.
5. Remove a starter and a cover of a bell-shaped case.
6. Turn off pallet bolts (see rice. Oil pallet of the engine 3F-E) also remove the oil pallet. If necessary displace the pallet easy blows of the wooden or rubber hammer.

Installation

PERFORMANCE ORDER
1. Remove the consolidation remains from the demountable planes of the block of cylinders and the pallet. Wash out the condensed planes solvent.
2. Establish new laying.
3. Install the pallet and wrap bolts. Tighten pallet bolts with the set moment, beginning an inhaling on corners and continuing in a diagonal order.
4. Further assembly are carried out upside-down. Fill in oil in the engine and replace the filter. Start the engine and be convinced of lack of leaks.