Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and operation of the car



Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   - 3.1. Engines 2F and 3F-E
      3.1.1. Technical characteristics
      3.1.2. Types of repair without dismantle of the engine
      3.1.3. Installation of the piston of the 1st cylinder in VMT
      3.1.4. Cover of a head of cylinders
      3.1.5. Side cover of the mechanism of gas distribution
      3.1.6. Yokes and bars of pushers
      3.1.7. Springs of valves, plates, oil scraper caps
      3.1.8. The soaking-up and final collectors
      3.1.9. Head of cylinders
      3.1.10. Pushers
      3.1.11. Crankshaft pulley
      3.1.12. Forward epiploon of the crankshaft
      3.1.13. Forward cover
      3.1.14. Cam-shaft and gear wheels of the drive
      3.1.15. Cam-shaft and support
      3.1.16. Replacement of bearings
      3.1.17. Oil pallet
      3.1.18. Oil pump
      3.1.19. Flywheel (drive plate of the hydrotransformer)
      3.1.20. Back epiploon of the crankshaft
      3.1.21. Details of a suspension bracket and engine
   + 3.2. Verkhneklapanny engine 1FZ-FE
   + 3.3. Dismantle and capital repairs of the engine
   + 3.4. Engine electric equipment
+ 4. Cooling systems, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries



3.1.18. Oil pump

GENERAL INFORMATION

Prevention

The oil pump is recommended to be changed at each removal of the pallet.

Before drawing a final conclusion, check oil pressure in the lubrication system.


Removal

PERFORMANCE ORDER
1. Remove the pallet.
2. Turn off 2 bolts of fastening of the pump.
3. Remove the pump with an oil receiver.
4. If the pump is faulty, then replace it. This unit is not subject to repair.

Installation

PERFORMANCE ORDER
1. Turn the pump roller so that the groove of the roller (1) coincided with shaft vents (2) rollers of the distributor. The pump has to come without effort into place. If the pump does not come, then remove it and tighten before coincidence of a groove with vents.
2. Further assembly is carried out upside-down. Fill and start the engine, be convinced of lack of a leak.