Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

GENERAL INFORMATION

Fastening of the evaporator on cars of a series 60, 62

Fastening of the evaporator on автомобилх series 80

Details of the evaporator of cars of a series 60, 62

1. Wires
2. Coupling relay
3. Holder
4. Thermoresistor
5. Broad valve

6. A tube with liquid coolant
7. Amplifier
8. Evaporator
9. Through sealant
10. Relay of conditioning of a back part of salon

Details of the evaporator of cars of a series 80

1, 2, 6. Sealant
3. Broad valve
4. Through sealant
5. Drain hose
7. Resistor

8. Evaporator
9. Thermoresistor
10. Bracket
11. Amplifier
12. Gate-type relay

Removal and installation

PERFORMANCE ORDER

1. Depressurize the conditioner and remove coolant car service.
2. Remove a glove box.
	3. Disconnect conditioner tubes on a partition of a motor compartment. Turn off the union, holding a key a reciprocal part not to curtail a tube.
4. On cars with the engine 1FZ-FE remove the processor block.
5. Turn off nuts and bolts of fastening and remove the evaporator.
6. Install the evaporator on a table, unscrew screws, remove latches, remove the top and lower half of the case of the evaporator and get the evaporator.
7. Get the thermoresistor from the evaporator, turn off bolts of fastening of the broad valve and two short tubes of giving and removal of coolant (see rice. Bolts of fastening of the condenser).
8. Clear the evaporator a special comb and blow compressed air.
9. If the new evaporator is installed, then enter about 40 g of the fresh oil recommended for your conditioner.
10. Further installation is carried out upside-down.
11. Replace a sealing ring and laying of the broad valve.
12. Fill the conditioner with coolant in the same workshop in which depressurization and removal of coolant were carried out.