Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and operation of the car



Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
- 4. Cooling systems, heating
   4.1. Technical characteristics
   4.2. Antifreeze
   4.3. Thermostat
   4.4. Krylchatka of the fan and hydraulic clutch
   4.5. Radiator and broad tank
   4.6. Oil cooler
   4.7. Cooling system pump
   4.8. Liquid temperature sensor
   4.9. Electric motor and chain of the fan of a heater
   4.10. Heater radiator
   + 4.11. Control panel of a heater and conditioner
   4.12. Air conditioning system and heating
   4.13. Conditioner moisture separator
   4.14. Conditioner compressor
   4.15. Condenser
   4.16. Evaporator and broad valve
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries



4.15. Condenser

GENERAL INFORMATION

Bolts of fastening of the condenser

1. Drain hose

2. Cowl lock bracket

3. A tube with liquid coolant

4. Collar

Removal and installation

PERFORMANCE ORDER
1. Depressurize the conditioner and remove coolant in car service.
2. Remove a radiator.
3. Remove a decorative lattice, a bracket of the lock of a cowl and the central rack.

4. Disconnect the highway of coolant on the right side, having turned off a bolt (it is specified by an arrow), muffle the union of tubes of coolant.
5. Turn off bolts of fastening of the condenser, displace the condenser back and remove from the car.
6. Install the condenser and arms, wrap bolts.
7. Be convinced of reliability of fastening of rubber pillows on the condenser.
8. Attach coolant tubes, replace ring laying.
9. If the new condenser is installed, then enter 50 the recommended brand, cubic see fresh oil.
10. Other details are established upside-down.
11. Fill the conditioner with coolant (it is carried out in the same workshop in which depressurization and removal of coolant were carried out).