Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and operation of the car

Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
- 11. Electric equipment
   11.1. Search of malfunctions
   11.2. Safety locks
   11.3. Fusible crossing points
   11.4. Breakers
   11.5. Relay
   11.6. Breaker of indexes of turn / alarm system
   11.7. A combination of switches on a steering column
   11.8. Lock of ignition and drum of the lock
   11.9. Indexes of level of fuel, pressure and temperature of oil
   11:10. Guard of devices
   11:11. Screen wiper electric motor
   11:12. Receiver and loudspeakers
   11:13. Antenna
   11:14. Heater of back glass
   11:15. Headlights
   11:16. Case of a halogen headlight
   11:17. Sound signal
   11:18. Replacement of lamps
   11:19. Side mirrors with the electric drive
   11:20. System cruise control
   11:21. Window regulator electric drive
   11:22. Electric drive of door locks
   11:23. Safety cushions
+ 12. Electrical circuitries

11.3. Fusible crossing points

GENERAL INFORMATION

Fusible crossing points are intended for protection of a chain at big current overloads. Crossing points are used in silnotochny chains which cannot be protected a usual safety lock.

On the FJ80 cars crossing points of cassette type are established, on the FJ60 and 62 cars solder crossing points are established.

Crossing points of cassette type on appearance are similar to safety locks. A part of cassette crossing points in addition fastens the screw.

Solder crossing points are not under repair. For replacement of such crossing points execute the following:

  – disconnect the battery from weight;
  – cut off a crossing point directly on the socket;
  – remove isolation from the termination of a wire on a piece about 13 mm;
  – fix the socket on a crossing point, having pressed out socket pads, and a propayayta connection by solder with a gloss oil vein;
  – reliably insulate connection by a tape;
  – connect the battery to weight and check work of this site of a chain.