Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
- 9. Suspension brackets and steering
9.1. Technical characteristics
9.2. Stabilizer of a forward suspension bracket and plugs
9.3. Forward and back shock-absorbers
9.4. Springs and plugs
9.5. Springs of suspension brackets (FJ80 car)
9.6. Cross bar (FJ80 car)
9.7. Levers of a suspension bracket (FJ80 car)
9.8. Rotary fist
9.9. Steering wheel
9.10. Steering drafts
9.11. Reducer
9.12. Pump of the hydraulic booster
9.13. Removal of air from the power steering
9.14. Wheels and tires
9.15. Angles of installation of forward wheels
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries
|
Prevention
Remove and install each lever separately. If necessary to remove two and more levers remove springs and prop up the bridge a jack.
LEVERS OF THE FORWARD SUSPENSION BRACKET
Removal
| PERFORMANCE ORDER |
| 1. Lift a car front. |
| 2. Establish under the bridge of a prop. |
|
|
3. Turn off a bolt nut on a frame arm. |
|
4. Turn off nuts (are specified by shooters) on a bridge arm. |
| 5. Remove the lever. If necessary hook it mount. |
| 6. Check a condition of plugs of the lever, existence on them of cracks, hardening and deformations. Replacement of plugs of levers is carried out in car service as the special equipment is required. |
|
Installation
| PERFORMANCE ORDER |
| 1. Installation is carried out upside-down. |
| 2. Delay all fastenings with the set moment. |
| 3. Tighten bolts of fastening of the lever under nominal loading of the car. |
|
LEVERS OF THE BACK SUSPENSION BRACKET
Removal
| PERFORMANCE ORDER |
| 1. Lift a back part of the car. |
| 2. Establish under the bridge of a prop. |
|
|
| 3. Turn off nuts of bolts (are specified by shooters) fastenings of the top lever on a frame arm (fig. on the right) and the bridge (a photo at the left). Remove the top lever. |
|
|
| 4. Turn off nuts of bolts of fastening of the lower lever on a frame arm (fig. at the left) and the bridge (are specified by shooters a photo on the right). Remove the lower lever. |
| 5. Check a condition of plugs of the lever, existence on them of cracks, hardening and deformations. Replacement of plugs of levers is carried out in car service as the special equipment is required. |
|
Installation
| PERFORMANCE ORDER |
| 1. Installation is carried out upside-down. |
| 2. Delay all fastenings with the set moment. |
| 3. Tighten bolts of fastening of the lever under nominal loading of the car. |
|
|
|
