Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and operation of the car



Toyota Land Cruiser
- 1. Maintenance instruction
   1.1. Introduction
   1.2. Control panel
   + 1.3. Governing bodies and instrumentations
   1.4. Identification numbers of the car
   1.5. Purchase of the old car or mysterious set of figures and letters
   1.6. The changed numbers
   1.7. Arrangement of elements
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries




eeac64fe


1. Maintenance instruction

1.1. Introduction

GENERAL INFORMATION

The FJ60, FJ62 and FJ80 Toyota Land Cruiser cars are equipped with a 4-door body the versatile person.

On the FJ60 cars which were issued in 1980-1987 the engine 2F was installed. Engines 3F-E were installed on the FJ62 cars (1988-1990). Cars of the FJ80 series were issued from 1989 to 1997 and were completed with two-shaft verkhneklapanny engines 1FZ-FE.

The engine 2F is carburetor, the drive of valves is provided with the bars connected to pushers ("pushrod" – the engine). Engines 3F-E and 1FZ-FE are injector, the drive of valves same as well as in the engine 2F. All cars all-wheel drive, main leading axis back. The drive on forward (back) wheels is provided via the transfer case and a reducer. Cars have dependent suspension brackets, forward and back axes are executed in the form of bridges. Elastic elements of both suspension brackets are springs (FJ60, FJ62) or springs with shock-absorbers (FJ80).

The reducer of steering is mounted to the left of the engine and connected with wheels levers and drafts. All cars are equipped with the power steering.

Brakes disk or drum, are equipped by the vacuum amplifier.

Identification numbers of the car

By drawing up operation manuals and catalogs of spare parts numerical codes of the car therefore at selection and installation of the necessary details it is necessary to know identification (identification) number of the car are applied.

Identification number

Identification number is used at registration of the car.

The plate with number of the car (VIN-number) is strengthened on the windshield feedwell from the driver. In the plate date of issue, year of this model and type of a body is specified.

Number of the engine

On engines 2F and 3F-E number is beaten out in the right part of the block of cylinders.
On engines 1FZ-FE number is beaten out in the left part of the block.

Manufacturer's certificate of origin

The plate with the certificate is put on a rack of a forward doorway. In the plate month and year of release, the manufacturer, bar codes, the conclusion about the validity of the car to operation and the full mass of the car are specified.

The plate with the indication of system of decrease in toxicity and the scheme of distributing of vacuum hoses (VECI label)

It is strengthened from the inside of a cowl. Contains data on system of decrease in toxicity and adjusting data.

Scheme of distributing of vacuum hoses

Numbers on transmission units

Number of the transfer case is stamped on a side part of a case.

Number of transmission contains in the plate strengthened on a side part of a case.