Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and operation of the car



Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
- 9. Suspension brackets and steering
   9.1. Technical characteristics
   9.2. Stabilizer of a forward suspension bracket and plugs
   9.3. Forward and back shock-absorbers
   9.4. Springs and plugs
   9.5. Springs of suspension brackets (FJ80 car)
   9.6. Cross bar (FJ80 car)
   9.7. Levers of a suspension bracket (FJ80 car)
   9.8. Rotary fist
   9.9. Steering wheel
   9.10. Steering drafts
   9.11. Reducer
   9.12. Pump of the hydraulic booster
   9.13. Removal of air from the power steering
   9.14. Wheels and tires
   9.15. Angles of installation of forward wheels
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries




eeac64fe


9.8. Rotary fist

GENERAL INFORMATION

Details of a rotary fist
1. laying
2. Plug
3. Pin
4. Nut
5. Lever
6. Bearing
7. Epiploon case cover
8. Persistent ring of the case of an epiploon
9. Fist
10. Bolt
11. Bearing cover
12. Remote laying

Removal

PERFORMANCE ORDER
1. Lift a car front.
2. Disconnect steering drafts from a fist.
3. Remove brake details.
4. Remove a half shaft.
5. Turn off epiploon case bolts.
6. Turn off nuts of the lever and remove conic washers (are specified by shooters).
7. Remove the top cover of bearings and remote laying.
8. Remove bearings and designate them ("right top", "right lower", etc.).
9. Remove the remains of old lubricant from bearings, a fork and a fist, having washed out solvent.
10. Check a condition of bearings, existence on rollers of cracks, a vykrashivaniye and wear tracks. Check a condition of rings of bearings in forks. Replace worn-out bearings, having removed rings with blows to a brass mandrel. Rings and holders of rollers change in a set.

Installation

PERFORMANCE ORDER
1. Put refractory lubricant in holders of bearings, with a force having pressed on the bearing so that lubricant came into holder separators.
2. Apply a thin film of lubricant on a guide.
3. Establish a new epiploon.
4. Install the top bearing in a fork, insert the lower bearing.
5. Holding the lower bearing, dress a fist on a fork of the bridge and establish laying and the top cover. Wrap bolts.
6. Install the lever, conic washers, wrap nuts. Tighten nuts and bolts of covers of the top and lower bearings with the set moment.
7. Check a preliminary tightness in bearings. If the moment differs from normal, then pick up thickness of remote laying, having removed a part of laying or having established new.

Prevention

Increase in thickness of laying reduces a preliminary tightness in bearings, reduction of thickness leads to increase in a tightness.


8. Further assembly is carried out upside-down.