Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and operation of the car



Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
- 9. Suspension brackets and steering
   9.1. Technical characteristics
   9.2. Stabilizer of a forward suspension bracket and plugs
   9.3. Forward and back shock-absorbers
   9.4. Springs and plugs
   9.5. Springs of suspension brackets (FJ80 car)
   9.6. Cross bar (FJ80 car)
   9.7. Levers of a suspension bracket (FJ80 car)
   9.8. Rotary fist
   9.9. Steering wheel
   9.10. Steering drafts
   9.11. Reducer
   9.12. Pump of the hydraulic booster
   9.13. Removal of air from the power steering
   9.14. Wheels and tires
   9.15. Angles of installation of forward wheels
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries




eeac64fe


9.9. Steering wheel

Removal

PERFORMANCE ORDER

Prevention

Part of cars is equipped with a safety cushion which is in a container in the center of a steering wheel. To exclude casual operation of system disconnect the battery from weight and wait not less than 90 sec. (time of the category of the reserve condenser).


1. Expose a wheel in the provision of driving on a straight line and disconnect the battery from weight.
2. Get caps of a wheel on each side and unscrew screws of fastening of a container with a pillow. To unscrew screws until the flute on a screw head does not come into an edge of the feedwell.
3. Remove a container with a safety cushion and disconnect the socket. All the time you keep an overlay of a container in the direction from yourself. It is necessary to put a container with a pillow so that the slip was turned up.
4. On cars without safety cushion unscrew screws of fastening of a sound signal.
5. Turn off a nut and designate the provision of a wheel concerning a shaft. Rotation of a shaft after removal of a steering wheel is not allowed.
6. Press a stripper a steering wheel. It is forbidden to remove a wheel blows to a nave.

Installation

PERFORMANCE ORDER
1. Establish a steering wheel on a shaft.
2. If on cars with a safety cushion forward wheels were incidentally turned, then it is necessary to center a spiral wire of a pillow. Be for this purpose convinced that wheels are exposed in situation on a straight line and turn the coil case counterclockwise against the stop and turn off clockwise on 3 turns, having combined tags of red color.
3. Installation of a wheel is carried out upside-down. Combine tags and tighten a nut with the set moment. Attach the socket to a safety cushion.