|
1. Turn off nuts (are specified by shooters) a flange of a half shaft and remove washers. |
|
2. Blows to a half shaft hairpin through a brass mandrel weaken conic washers and remove them from a nave. |
|
3. Screw 2 bolts in technological openings of a flange and turning, displace a half shaft from a nave. Remove a half shaft. |
| 4. Examine a half shaft. |
|
5. If necessary get an epiploon. |
| 6. Before installation of a half shaft slightly grease epiploon edges with jellied lubricant. |
| 7. Before assembly clear a surface and replace laying of a flange. |
| 8. Insert a half shaft and enter into differential gear wheel vents. |
| 9. Further assembly is carried out upside-down. |
