Repair and operation of the FJ60, FJ62 and FJ80 Toyota Land Cruiser 1980 - 1997 cars - 3.4.3. Power cables//Toyota

Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and operation of the car



Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Engines 2F and 3F-E
   + 3.2. Verkhneklapanny engine 1FZ-FE
   + 3.3. Dismantle and capital repairs of the engine
   - 3.4. Engine electric equipment
      3.4.1. Technical characteristics
      3.4.2. Battery
      3.4.3. Power cables
      + 3.4.4. System of ignition
      3.4.5. Ignition coil
      3.4.6. Ignition distributor
      3.4.7. Block of electronic ignition
      3.4.8. Induction sensor
      + 3.4.9. System of a charge of the battery
      3.4.10. Generator
      3.4.11. Generator details
      3.4.12. System of launch of the engine
      3.4.13. Starter electric motor
      3.4.14. Traction relay of a starter (car of 1980-87 of release)
+ 4. Cooling systems, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries
eeac64fe



3.4.3. Power cables

Check and replacement

PERFORMANCE ORDER
1. Periodically check cables on all length, damage, cracking or a burn-out of isolation of cables, and also corrosion are not allowed. Unreliable connection of the battery can be a cause of failures at launch of the engine, and also deterioration in operational qualities of the engine.
2. Check a condition of connections of poles with plugs, existence on them of corrosion, cracks and weakening of fastening of wires. Existence of the white shelled raid under isolation in the place of the plug demonstrates corrosion of conductors of a cable and need of its replacement.
3. Check existence of corrosion and deformations on plugs and a condition of bolts of fastening.
4. Disconnect old cables from the battery, track laying of cables on their length and find places of their fastening to a starter and to weight, disconnect cables from the traction relay of a starter and weight. Remember a route along which the cable is laid to lay a new cable to the place of replaced. Track that after installation the cable was not tense.
5. If cables are replaced new, then getting new cables, take with yourself old. It is extremely important that new cables in accuracy corresponded to old.
6. Clear carvings of fastening of cables of the battery on the traction relay of a starter and on a body, remove corrosion traces.