Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and operation of the car

Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Engines 2F and 3F-E
   - 3.2. Verkhneklapanny engine 1FZ-FE
      3.2.1. Technical characteristics
      3.2.2. Types of repair without dismantle of the engine
      3.2.3. Cover of a head of cylinders
      3.2.4. The soaking-up collector
      3.2.5. Final collector
      3.2.6. Cam-shafts and pushers
      3.2.7. Head of cylinders
      3.2.8. Cover of the chain drive of cam-shafts
      3.2.9. Forward epiploon of the crankshaft
      3.2.10. Oil pallet
      3.2.11. Oil pump
      3.2.12. Flywheel (drive plate of the hydrotransformer)
      3.2.13. Back epiploon of the crankshaft
      3.2.14. Details of a suspension bracket and engine
   + 3.3. Dismantle and capital repairs of the engine
   + 3.4. Engine electric equipment
+ 4. Cooling systems, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries


3.2.3. Cover of a head of cylinders


1. Disconnect the battery from weight.
2. Remove an air inlet, disconnect hoses of ventilation of a case from a cover.
3. Remove caps of candles, disconnect wires.
4. Disconnect cables of a butterfly valve and a cruise control and take aside. Remove a hook for posting of the engine in a forward part of the soaking-up collector.
5. Turn off bolts of a cover of a head of cylinders, uncover also laying. If the cover does not give in, then displace it blows of the hammer through a soft pro-rate, or carefully open consolidation by the pallet.


1. Carefully clear the condensed surfaces of a cover and a head of cylinders, remove oil traces. Establish new laying in a cover flute (laying can be not changed if it did not harden and on it there are no damages). Track safety of sealants of casings of candles (are specified by shooters).
2. Apply sealant on semicircular caps (are specified by an arrow) and establish them on a head of cylinders.
3. Establish a cover and wrap bolts.
4. Evenly tighten cover bolts with the set moment.
5. Establish other details, start the engine and be convinced of lack of a leak.