Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and operation of the car

Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
- 10. Body
   10.1. Maintenance and repair
   10.2. Vinyl finishing
   10.3. Upholstery and rugs
   10.4. Repair of insignificant damages
   10.5. Repair of considerable damages
   10.6. Loops and locks
   10.7. Windshield and motionless glasses
   10.8. Cowl
   10.9. Latch of a cowl and cable of the drive
   10:10. Forward lattice
   10:11. Forward wing
   10:12. Internal panel of a door
   10:13. Door lock, switch of the lock and handle
   10:14. Door glass
   10:15. Window regulator
   10:16. Side mirrors
   10:17. Door
   10:18. Door of a back compartment
   10:19. Back cover (top door of a back compartment)
   10:20. Casing of a steering column
   10:21. Panels of forward facing of salon
   10:22. Average floor section
   10:23. Forward facing panel of salon
   10:24. Seats
   10:25. Bumpers
+ 11. Electric equipment
+ 12. Electrical circuitries


10:18. Door of a back compartment



Works are performed together.

Removal and installation

1. Lift a door of a back compartment and remove the internal decorative panel of a door.
2. Disconnect all sockets of a door.
3. Cover the lower part of an aperture with rags.
4. Disconnect levers of a door of a back compartment while the assistant supports a door. The bolt of fastening of the lever of a door of a back compartment is specified by an arrow.
5. Before an otvorachivaniye of bolts of fastening of a door of a back compartment (are specified by shooters) outline contours of loops. Turn off bolts of fastening of loops to a door of a back compartment and remove a door.
6. Installation is carried out upside-down.


1. Adjustment of a door of a back compartment concerning a body is reached by movement of a door at the released bolts of fastening of loops to a body or to a door. The door is considered adjusted if the top edge is parallel to an edge of the back panel. If adjustment of a door is not reached by movement in loops, then between loops and a body (door) it is necessary to lay remote laying (are available on sale).
2. For adjustment of provision of the closed door be convinced that the latch of the lock makes contact with the central part of a clamp. Otherwise adjust, moving a clamp up-down.
3. Adjust gearing of a latch with a clamp and the provision of a door, moving a clamp up-down, or back and forth.