Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and operation of the car

Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
- 10. Body
   10.1. Maintenance and repair
   10.2. Vinyl finishing
   10.3. Upholstery and rugs
   10.4. Repair of insignificant damages
   10.5. Repair of considerable damages
   10.6. Loops and locks
   10.7. Windshield and motionless glasses
   10.8. Cowl
   10.9. Latch of a cowl and cable of the drive
   10:10. Forward lattice
   10:11. Forward wing
   10:12. Internal panel of a door
   10:13. Door lock, switch of the lock and handle
   10:14. Door glass
   10:15. Window regulator
   10:16. Side mirrors
   10:17. Door
   10:18. Door of a back compartment
   10:19. Back cover (top door of a back compartment)
   10:20. Casing of a steering column
   10:21. Panels of forward facing of salon
   10:22. Average floor section
   10:23. Forward facing panel of salon
   10:24. Seats
   10:25. Bumpers
+ 11. Electric equipment
+ 12. Electrical circuitries


10:12. Internal panel of a door

Removal and installation

1. Disconnect the battery from weight.
2. Remove a decorative overlay of the internal door handle.
3. On cars with a manual window regulator remove the window regulator handle for what with remove a latch, having hooked it the thin bent tool.
4. On cars with the electric drive of a window regulator hook and get a plate of the switch from an armrest and disconnect the socket.
5. Unscrew screws and remove an armrest.
6. Unscrew fastening screws on the lower edge of the panel of a door and get panel latches, having pushed the tool between a slip and a door.
7. Make sure that all latches and screws are removed, disconnect the panel and switch-off all sockets. Remove the panel, having a little given up.
8. To provide access to details of the internal device of a door remove an arm of the internal panel (if it is provided) and carefully get the water filter. At assembly install the screen into place, for fixing slightly grease the screen.
9. Installation is carried out upside-down.