Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and operation of the car

Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
- 5. Fuel and exhaust systems
   - 5.1. Carburetor engines
      5.1.1. Fuel pump and pressure of fuel
      5.1.2. Fuel pipe
      - 5.1.3. Fuel tank
         5.1.3.1. Cleaning and repair of the fuel tank
      5.1.4. Fuel pump
      5.1.5. Fuel level sensor
      5.1.6. Air filter
      5.1.7. Cable of the drive of a butterfly valve
      + 5.1.8. Carburetor
      5.1.9. Service of the exhaust system
   + 5.2. Engines with fuel injection
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries

5.1.3. Fuel tank

GENERAL INFORMATION

Fuel tank of cars of the FJ60, FJ62 series

1. Separator of vapors
2. Connector of tubes
3. Stopper
4. Jellied mouth
5. Buffers
6. Fuel level sensor

7. Laying
8. Tank
9. Coupling tapes
10. Drain stopper
11. Fuel pump

Fuel tank of cars of the FJ80 series

1. Ventilating tube
2. Hose
3. Hose of an inlet branch pipe
4. Mouth pipe
5. Stopper
6. Inlet pipe of a mouth
7. Tank

8. Tank guard
9. Coupling tapes
10. Drain stopper
11. Laying
12. Slip
13. Buffers
14. Pump and fuel level sensor

Removal and installation

Prevention

When working follow fire safety regulations.

PERFORMANCE ORDER

Prevention

It is necessary to remove the fuel tank after its full devastation. On some cars the drain stopper is provided in a tank. In the absence of a drain stopper devastate a tank a trip with the subsequent operation of the engine idling, or merge gasoline through a hose with the rubber manual pump (is available on sale).

1. Turn off a stopper of a jellied mouth of a tank to take off residual pressure.

2. Disconnect the battery from weight.

3. Merge gasoline.

4. Lift the car and establish on supports.

5. Disconnect from a tank and muffle hoses and tubes.

6. Weaken a collar and disconnect a mouth from a tank.

7. Turn off nuts and remove a tank guard.

8. Substitute a prop under a tank.

9. Disconnect coupling tapes and take aside.

10. Lower a tank a little and disconnect sockets and a wire on weight.

11. Remove a tank.

12. On a part of cars the additional tank which is removed just in the same order is provided.

13. Installation is carried out upside-down.