Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and operation of the car

Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
- 5. Fuel and exhaust systems
   + 5.1. Carburetor engines
   - 5.2. Engines with fuel injection
      5.2.1. Technical characteristics
      5.2.2. Decompression of fuel system
      + 5.2.3. Fuel pump and pressure of fuel
      5.2.4. Fuel pipes and joints
      5.2.5. Fuel pump
      5.2.6. Fuel level sensor
      5.2.7. Air filter
      5.2.8. Cable of the drive of a butterfly valve
      + 5.2.9. System of electronic injection of fuel (EFI system)
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries


5.2.5. Fuel pump


1. Execute a decompression.
2. Disconnect the battery from weight.
3. Remove the fuel tank (on cars of 1988-90)
4. On cars since 1991 of release remove an average seat and the hatch.
5. Disconnect the socket and tubes of a fuel pipe.
6. Turn off bolts (are specified by shooters) fastenings of the fuel pump and the fuel level sensor.
7. Having inclined, carefully get from the fuel tank the fuel pump assembled with the sensor.
8. Having carefully hooked the lower part of the pump get the pump from an arm.
9. Remove rubber laying from the pump.
10. Remove a lock washer of fastening of the filter of rough cleaning to the pump.
11. Remove the filter and check its state. In case of strong pollution replace the filter.
12. If only replacement of the filter of rough cleaning that is made install the new filter, a washer, laying and insert the lower part of the pump back into an arm. Install the pump assembled with the sensor in the fuel tank.
13. If the fuel pump is replaced, then remove a collar and disconnect a hose.
14. Disconnect wires from conclusions of the pump and remove the pump.


1. Installation is carried out upside-down.
2. Replace laying of unions of fuel pipes.