Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and operation of the car



Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
- 8. Brake system
   8.1. Technical characteristics
   + 8.2. ABS system
   8.3. Blocks of disk brakes (forward or back)
   8.4. Brake support
   8.5. Brake disk
   8.6. Blocks of drum brakes
   8.7. Wheel cylinder of brakes
   8.8. Main cylinder of brakes
   8.9. Hoses and tubes of a hydraulic actuator
   8.10. Removal of air from a hydraulic actuator of brakes
   8.11. Vacuum amplifier of brakes
   8.12. Blocks of the emergency brake of back disk brakes
   8.13. Adjustment of the emergency brake
   8.14. Cable of the emergency brake
   8.15. Braking signal switch
   8.16. The regulator of pressure of back brakes (dosing and perepuskny the valve)
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries




eeac64fe


8.9. Hoses and tubes of a hydraulic actuator

GENERAL INFORMATION

The condition of hoses and tubes is recommended to check each 6 months. At detection of cracks, dribbles, swellings and other damages replace a hose.

Replacement of hoses of forward brakes

PERFORMANCE ORDER
1. Lift the car and remove a wheel.
2. Turn out the tube union from a hose.
3. Get a bracket (2) and pass a hose (3) through an opening in an arm (1 – a tube).
4. Turn off a bolt of the union and disconnect a hose from a support.
5. At assembly replace copper laying, combine a ledge on a hose with an opening in a support and tighten an union bolt with the set moment.
6. Pass a hose in an arm, screw an union nut, insert a bracket and tighten a nut.
7. Remove air from support cylinders (see subsection 8.10).
8. Establish a wheel and lower the car.

Replacement of hoses of back brakes

PERFORMANCE ORDER
1. Perform operations on subitem 1-3.
2. Remove air from the support cylinder (see subsection 8.10).

Replacement of tubes

PERFORMANCE ORDER
1. When replacing tubes track that on all route they were fixed by collars.
2. The form of curved new tubes has to correspond to a form of replaced.
3. Installation only of steel tubes, in accuracy corresponding to make of the car is allowed.