Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
- 8. Brake system
8.1. Technical characteristics
+ 8.2. ABS system
8.3. Blocks of disk brakes (forward or back)
8.4. Brake support
8.5. Brake disk
8.6. Blocks of drum brakes
8.7. Wheel cylinder of brakes
8.8. Main cylinder of brakes
8.9. Hoses and tubes of a hydraulic actuator
8.10. Removal of air from a hydraulic actuator of brakes
8.11. Vacuum amplifier of brakes
8.12. Blocks of the emergency brake of back disk brakes
8.13. Adjustment of the emergency brake
8.14. Cable of the emergency brake
8.15. Braking signal switch
8.16. The regulator of pressure of back brakes (dosing and perepuskny the valve)
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries
|
Regulator arrangement
|
|
The regulator of pressure is intended for compensation of pressure in back brakes at increase in load of a back axis. The unit is located over a beam of the back bridge and contains the valve, the torsion and an adjusting bolt. |
During removal of air from brakes the regulator is pumped over in the last turn.
If abnormal operation of the regulator is noted, then hand over the car in car service for check and adjustment.
When replacing the regulator apply a control tag on an adjusting nut which should be tightened and exposed on this tag. |
|
