Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and operation of the car



Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
- 7. Transmission
   + 7.1. Mechanical transmission
   + 7.2. Automatic transmission
   + 7.3. Transfer case
   - 7.4. Coupling, driveshafts, half shafts and leading bridges
      7.4.1. Technical characteristics
      - 7.4.2. Coupling
         7.4.2.1. Coupling details
         7.4.2.2. Release bearing
         7.4.2.3. The directing bearing
         7.4.2.4. Main cylinder of coupling
         7.4.2.5. Working cylinder of coupling
         7.4.2.6. Coupling hydraulic actuator
         7.4.2.7. Coupling pedal
      + 7.4.3. Cardan shaft, reducer and axes
      7.4.4. Forward half shaft and epiploon
      + 7.4.5. Back (forward) bridge
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries




eeac64fe


7.4.2.3. The directing bearing

GENERAL INFORMATION

The ball directing bearing is a support of a main shaft of the check point and is pressed in an opening in a back flange of the crankshaft. A condition of the bearing it is necessary to check every time when coupling is removed. If there are doubts concerning a condition of the bearing, then it should be replaced. At removal of the engine the bearing changes without fail.

Check and replacement

PERFORMANCE ORDER
1. Remove the transmission.
2. Remove coupling.
3. Wipe lubricant and check a condition of the bearing, having lit it in an opening.
4. At detection of damages of a sock of a main shaft, or in case of the complicated rotation, a vypressuyta the bearing.
5. In the absence of a stripper remove the bearing by means of hydroblow.
6. For this purpose fill deepening in the crankshaft with dense lubricant, having carefully removed air.
7. Strike the mandrel conductor inserted into the bearing. Diameter of a mandrel has to be a little less internal diameter of the bearing.
8. Get the bearing and remove all lubricant.
9. Press the new bearing the mandrel resting against an external holder.
10. Establish coupling and the transmission.