Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and operation of the car

Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
- 5. Fuel and exhaust systems
   - 5.1. Carburetor engines
      5.1.1. Fuel pump and pressure of fuel
      5.1.2. Fuel pipe
      + 5.1.3. Fuel tank
      5.1.4. Fuel pump
      5.1.5. Fuel level sensor
      5.1.6. Air filter
      5.1.7. Cable of the drive of a butterfly valve
      + 5.1.8. Carburetor
      5.1.9. Service of the exhaust system
   + 5.2. Engines with fuel injection
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries

5.1.7. Cable of the drive of a butterfly valve

Removal

PERFORMANCE ORDER

1. Unhook a cable from draft of the gate.

2. Turn off nuts of fastening of a cover of a cable and get a cover from an arm.

3. In salon remove the lower panel from the driver, having unscrewed screws and having released latches.

4. Disconnect a cable from a pedal for what extend a cable and give up.

5. Turn off bolts of fastening of the holder of a cable on a partition of a motor compartment and get a cable, having stretched in a motor compartment.

Installation

PERFORMANCE ORDER

1. Installation is carried out upside-down.

2. When laying a cable provide gaps not less than 5 cm from moving parts.

3. On a partition of a motor compartment grease a cover with sealant to exclude hit in salon of water.

Adjustment

The concrete order of adjustment of a cable of the gate is not provided. Only kick cable - down - the mode is regulated.