Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and operation of the car



Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
- 8. Brake system
   8.1. Technical characteristics
   + 8.2. ABS system
   8.3. Blocks of disk brakes (forward or back)
   8.4. Brake support
   8.5. Brake disk
   8.6. Blocks of drum brakes
   8.7. Wheel cylinder of brakes
   8.8. Main cylinder of brakes
   8.9. Hoses and tubes of a hydraulic actuator
   8.10. Removal of air from a hydraulic actuator of brakes
   8.11. Vacuum amplifier of brakes
   8.12. Blocks of the emergency brake of back disk brakes
   8.13. Adjustment of the emergency brake
   8.14. Cable of the emergency brake
   8.15. Braking signal switch
   8.16. The regulator of pressure of back brakes (dosing and perepuskny the valve)
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries




eeac64fe


8.7. Wheel cylinder of brakes

GENERAL INFORMATION

Details of the wheel cylinder of brakes with a horizontal arrangement of blocks


Details of the wheel cylinder of brakes with a vertical arrangement of blocks

1. Cap

2. The union for pumping

3. Cover

4. Piston

5. Cuff

6. Spring

7. Cylinder

The scheme of installation of cylinders on brakes with a horizontal arrangement of blocks

1. Left wheel
2. Right wheel
3. Left carving
4. Right carving

Prevention

At detection of a leak replace the cylinder. Cylinders change only in couple on an axis.


Removal

PERFORMANCE ORDER
1. Lift the car.
2. Remove blocks.
3. Clear the wheel cylinder.
4. Unscrew the union (A) of a hydraulic actuator and bolts (V), a tube not to disconnect.
5. Turn off bolts of fastening of the cylinder.
6. Remove the cylinder and muffle tubes.

Dismantling

PERFORMANCE ORDER
1. Turn out the union for pumping, remove dustproof covers, get pistons with cuffs and springs.
2. Wash out details alcohol or brake fluid.
3. Dry and blow channels of the cylinder.
4. Check a condition of a surface of the cylinder. At detection of strong damages (scratches) replace the cylinder.
5. Grease new cuffs with brake fluid.
6. Install cuffs on pistons so that edges of cuffs were turned in the cylinder.
7. Collect the cylinder.
8. Install the cylinder, wrap bolts by hand. Wrap the union and tighten fastening bolts (see rice. The scheme of installation of cylinders on brakes with a horizontal arrangement of blocks).
9. Tighten the union and establish blocks.
10. Remove air from a hydraulic actuator.
11. Check work of brakes.