Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and operation of the car



Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
- 8. Brake system
   8.1. Technical characteristics
   + 8.2. ABS system
   8.3. Blocks of disk brakes (forward or back)
   8.4. Brake support
   8.5. Brake disk
   8.6. Blocks of drum brakes
   8.7. Wheel cylinder of brakes
   8.8. Main cylinder of brakes
   8.9. Hoses and tubes of a hydraulic actuator
   8.10. Removal of air from a hydraulic actuator of brakes
   8.11. Vacuum amplifier of brakes
   8.12. Blocks of the emergency brake of back disk brakes
   8.13. Adjustment of the emergency brake
   8.14. Cable of the emergency brake
   8.15. Braking signal switch
   8.16. The regulator of pressure of back brakes (dosing and perepuskny the valve)
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries




eeac64fe


8.12. Blocks of the emergency brake of back disk brakes

Check and replacement

PERFORMANCE ORDER
1. Remove a brake disk.
2. Clear the mechanism of the emergency brake.
3. Check the residual thickness of frictional slips. Replace blocks if material thickness less than 1,0 mm.
4. Remove springs of the emergency brake.
5. Remove a strut of blocks.
6. Remove a clamping spring of a back block.
7. Remove a back block and the regulator.
8. Remove a clamping spring of a forward block, disconnect a cable from the lever and remove a block.
9. Remove with the screw-driver a lock washer from an axis of the lever of the emergency brake, remove the lever, laying and an axis.
10. Rearrange these details on a new block and press out a washer.
11. Grease with a thin layer of refractory lubricant the rubbing surface of a board of a brake and a carving.
12. Grease with a thin layer of refractory lubricant the sliding surface of the regulator in the specified places.
13. Attach a cable to the lever and establish a forward block.
14. Fix a block by a spring.
15. Put on the lower spring and install the regulator.
16. Establish a back block.
17. Fix a block by a spring.
18. Put on the top spring a back block.
19. Establish a strut so that the spring was turned forward.
20. Establish returnable springs of blocks.
21. Establish a disk of a brake and fix, having screwed nuts of wheels.
22. Remove a cap from a disk.
23. Adjust blocks for what, rotating a regulator hairpin cogwheel, part blocks against the stop in a drum (the drum at the same time should not be rotated) and take away, having turned off a hairpin on 8 teeth.
24. Establish a support arm, tighten bolts with the set moment.
25. Establish a wheel.
26. Check number of clicks of the lever of the emergency brake before full braking which has to be equal to 5. Otherwise adjust (see subsection 8.13).
27. For extra earnings of blocks of a brake arrive as follows.
28. Moving with a speed of 50 km/h on the flat dry highway, include a brake, having made effort of 8 kgfs for the lever and pass about 0,5 km then release the lever.
29. Repeat this procedure 2–3 times, allowing to cool down previously to blocks.