Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and operation of the car

Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
- 8. Brake system
   8.1. Technical characteristics
   + 8.2. ABS system
   8.3. Blocks of disk brakes (forward or back)
   8.4. Brake support
   8.5. Brake disk
   8.6. Blocks of drum brakes
   8.7. Wheel cylinder of brakes
   8.8. Main cylinder of brakes
   8.9. Hoses and tubes of a hydraulic actuator
   8.10. Removal of air from a hydraulic actuator of brakes
   8.11. Vacuum amplifier of brakes
   8.12. Blocks of the emergency brake of back disk brakes
   8.13. Adjustment of the emergency brake
   8.14. Cable of the emergency brake
   8.15. Braking signal switch
   8.16. The regulator of pressure of back brakes (dosing and perepuskny the valve)
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries

8.10. Removal of air from a hydraulic actuator of brakes

GENERAL INFORMATION

Need of pumping arises after a detachment of tubes of the main cylinder or at strong lowering of the level in a tank.

When dismantling a hydraulic actuator of one wheel it is possible to be limited to removal of air only from the understanding cylinder.

If the highway from the main cylinder to wheel understood, then it is possible to be limited to removal of air only from this highway.

PERFORMANCE ORDER

1. Press several times a pedal of a brake and remove residual depression in the amplifier.
2. Before pumping restore liquid level in a tank and during pumping support level, without allowing emptying of a tank. Fill in only fresh liquid.
3. Prepare liquid, a vessel, a hose for pumping and a key for an union otvorachivaniye.
4. Begin pumping with a back right wheel.
	5. Attach a hose to the union, lower other end of a hose in a vessel with brake fluid.
6. Ask the assistant to press slowly several times a pedal of a brake and to hold.
7. Unscrew the union, and later 2 sec. after the stream of the liquid following with bubbles will weaken, tighten the union. Ask the assistant to release a pedal.
8. Repeat the procedure until in the following liquid vials of air do not cease to be observed.
9. Tighten the union.
10. Perform these operations in the sequence: left back wheel, the right forward, left forward.
11. Upon termination of pumping restore liquid level in a tank.
	12. Remove air from pressure regulator (dosing and perepuskny valves), having repeated the actions stated above (1 – the union for pumping).
13. Check rigidity of a pedal and work of brakes.
14. If necessary repeat the procedure.