Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and operation of the car

Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
- 7. Transmission
   + 7.1. Mechanical transmission
   + 7.2. Automatic transmission
   + 7.3. Transfer case
   - 7.4. Coupling, driveshafts, half shafts and leading bridges
      7.4.1. Technical characteristics
      + 7.4.2. Coupling
      - 7.4.3. Cardan shaft, reducer and axes
         7.4.3.1. Check of driveshafts and hinges
         7.4.3.2. Removal and installation of the driveshaft
         7.4.3.3. Cardan hinges
         7.4.3.4. The blocking nave
      7.4.4. Forward half shaft and epiploon
      + 7.4.5. Back (forward) bridge
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries

7.4.3.3. Cardan hinges

GENERAL INFORMATION

Details of the cardan hinge

1. Lock ring

2. Bearing

3. Crosspiece

4. A fork with a flange

Replacement

PERFORMANCE ORDER

1. Remove the driveshaft.
2. Clamp a shaft in a vice, designate the provision of forks of the hinge and get lock rings of glasses of bearings.
3. Vypressuyte bearing glass.
	4. For this purpose establish a crosspiece in a vice via the plug on the one hand and through a mandrel with another.
	5. Squeeze a vice until the glass of the bearing does not appear at the edge of a fork. An alligator wrench or flat-nose pliers get a bearing glass.
6. Rearrange a mandrel and the plug and a vypressuyta an opposite glass.
7. Having removed glasses, carefully clear a fork.
8. Put lubricant in new glasses that at assembly needles were not scattered.
9. Establish a crosspiece and insert a glass into a fork.
10. Orient a crosspiece so that the direction of a butterdish coincided with the direction of a butterdish on the opposite end of a shaft (if butterdishes are provided).
11. Insert a crosspiece into the bearing, insert the opposite bearing.
12. Carefully, without having damaged epiploons, press bearings, having combined them with crosspiece necks.
13. Establish rings.
14. If necessary kill with strong blow to a fork that rings became in the place.
15. If rings do not come into flutes, then disassemble the hinge and check freedom of rotation of bearings on crosspiece necks.
16. Install the driveshaft.
17. Grease crosspieces (if there are butterdishes).