Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and operation of the car



Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
- 7. Transmission
   + 7.1. Mechanical transmission
   + 7.2. Automatic transmission
   + 7.3. Transfer case
   - 7.4. Coupling, driveshafts, half shafts and leading bridges
      7.4.1. Technical characteristics
      - 7.4.2. Coupling
         7.4.2.1. Coupling details
         7.4.2.2. Release bearing
         7.4.2.3. The directing bearing
         7.4.2.4. Main cylinder of coupling
         7.4.2.5. Working cylinder of coupling
         7.4.2.6. Coupling hydraulic actuator
         7.4.2.7. Coupling pedal
      + 7.4.3. Cardan shaft, reducer and axes
      7.4.4. Forward half shaft and epiploon
      + 7.4.5. Back (forward) bridge
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries




eeac64fe


7.4.2.4. Main cylinder of coupling

GENERAL INFORMATION

Details of the main cylinder of coupling of cars of early releases

1. Washer
2. Tank
3. Pin
4. Forelock
5. Cover
6. Spring ring
7. Pusher
8. Cup
9. Piston
10. Highway union
11. Cylinder

Details of the main cylinder of coupling of cars of late releases

1. Tank stopper
2. Sealant
3. Spring ring
4. Cover
5. Pin
6. Forelock
7. Pusher
8. Cup
9. Piston
10. Highway union
11. Cylinder
12. Pin tank krepelniya
13. Tank
14. Float
15. Cylinder assembled

Dismantling and assembly

PERFORMANCE ORDER

Prevention

Before dismantling get ремкомплект the cylinder.


1. Disconnect the battery from weight.
2. Disconnect a pusher of the main cylinder from a coupling pedal. For removal of the cylinder of coupling to a rasshplintuyta and a lostanta an axis (it is specified by an arrow).
3. Disconnect the highway of a hydraulic actuator from the cylinder, merge liquid and muffle tubes.
4. Turn off nuts and remove the cylinder.
5. Turn off an internal bolt and remove a tank.
6. On cars of late release beat out the sprung pin of fastening of a tank.
7. Remove a cover and a spring ring.
8. Get a pusher, a washer and the piston.
9. Check a condition of an internal surface of the cylinder. At detection of zadir, scratches or the painted sites replace the cylinder.
10. If an internal surface in good shape, then replace only a sealant (are delivered in a remkomplekta).
11. Before installation of details they need to be greased with brake fluid.
12. Further assembly is carried out upside-down.

Installation

PERFORMANCE ORDER
Installation is carried out upside-down. Remove air from a hydraulic actuator.