Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and operation of the car



Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
- 7. Transmission
   + 7.1. Mechanical transmission
   - 7.2. Automatic transmission
      7.2.1. Technical characteristics
      + 7.2.2. Diagnostics of transmission
      7.2.3. Draft of the selector of transmission
      7.2.4. System of fixing of the selector
      7.2.5. Gate drive cable
      7.2.6. The blocking switch
      7.2.7. Transmission support
      7.2.8. Removal and installation of transmission
   + 7.3. Transfer case
   + 7.4. Coupling, driveshafts, half shafts and leading bridges
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries




eeac64fe


7.2.4. System of fixing of the selector

GENERAL INFORMATION

Arrangement of knots of system of fixing of the selector

1. Solenoid of blocking of a key
2. Solenoid of blocking of the selector
3. Control unit of the selector
4. Switch of blocking of the selector
5. Braking signal switch

The system provides fixing of the selector in provisions Park or Neutral at the pressed brake pedal. All works on service of system except described below are performed in car service.

Check

PERFORMANCE ORDER
1. For access to knots of system it is necessary to remove floor section.
2. Disconnect the socket and give tension from the battery on conclusions of the solenoid of blocking of the selector. If there is no characteristic click, then replace the solenoid.
3. Disconnect the socket of the solenoid of blocking of a key and check resistance between conclusions 1i 5 (fig. at the left – for the car of 1991-95), between conclusions 7 and 8 (fig. on the right – for the car since 1995) which has to be 12–17 Ohms.
4. Disconnect the socket from the switch of blocking of the selector and check resistance between the specified conclusions.
5. In position of the Park selector between conclusions of P and P1 there has to be a chain.
6. In position of the Park selector and the pressed button between conclusions of P and P1 and P and P2 there has to be a chain.
7. In other provisions of the R, N, D, 2 and L selector between conclusions of P and P2 there has to be a chain.
8. If results of checks differ, then replace faulty details and repeat checks.