Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and operation of the car



Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling systems, heating
- 5. Fuel and exhaust systems
   + 5.1. Carburetor engines
   - 5.2. Engines with fuel injection
      5.2.1. Technical characteristics
      5.2.2. Decompression of fuel system
      + 5.2.3. Fuel pump and pressure of fuel
      5.2.4. Fuel pipes and joints
      5.2.5. Fuel pump
      5.2.6. Fuel level sensor
      5.2.7. Air filter
      5.2.8. Cable of the drive of a butterfly valve
      - 5.2.9. System of electronic injection of fuel (EFI system)
         5.2.9.1. Check of system of electronic injection of fuel
         - 5.2.9.2. Units of system of electronic injection of fuel
            5.2.9.2.1. Case of a butterfly valve
            5.2.9.2.2. Sensor of an angle of rotation of a butterfly valve
            5.2.9.2.3. Fuel pressure regulator
            5.2.9.2.4. Valve of the regulator of turns of idling
            5.2.9.2.5. Distributor of fuel and nozzle
            5.2.9.2.6. Leveling camera
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries




eeac64fe


5.2.9.2.6. Leveling camera

Removal

PERFORMANCE ORDER

Prevention

Works are performed on the cold engine.


1. Disconnect the battery from weight.
2. Disconnect all sockets from the camera.
3. Disconnect a cable of the drive of the gate and draft of transmission.
4. Remove an oil indicator branch pipe arm.
5. Accurately designate and disconnect all vacuum hoses.
6. Disconnect a hose of system of ventilation of a case.
7. Turn off a bolt and remove an arm (if it is provided).
8. Disconnect and muffle hoses of cooling liquid.
9. Turn off bolts and remove the camera.

Installation

PERFORMANCE ORDER
1. Clear and check a condition of the demountable planes of a collector and the camera. Replace laying of the lower inlet collector. Mount on an inlet collector the camera assembled with the gate case. Be convinced of correctness of installation of laying.
2. Wrap fastening bolts to an inlet collector, tighten bolts with the moment specified in (see subsection 3.2.1). Further installation is carried out upside-down.