Toyota Land Cruiser

FJ60, FJ62 and FJ80 1980-1997 of release

Repair and operation of the car

Toyota Land Cruiser
+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Engines 2F and 3F-E
   - 3.2. Verkhneklapanny engine 1FZ-FE
      3.2.1. Technical characteristics
      3.2.2. Types of repair without dismantle of the engine
      3.2.3. Cover of a head of cylinders
      3.2.4. The soaking-up collector
      3.2.5. Final collector
      3.2.6. Cam-shafts and pushers
      3.2.7. Head of cylinders
      3.2.8. Cover of the chain drive of cam-shafts
      3.2.9. Forward epiploon of the crankshaft
      3.2.10. Oil pallet
      3.2.11. Oil pump
      3.2.12. Flywheel (drive plate of the hydrotransformer)
      3.2.13. Back epiploon of the crankshaft
      3.2.14. Details of a suspension bracket and engine
   + 3.3. Dismantle and capital repairs of the engine
   + 3.4. Engine electric equipment
+ 4. Cooling systems, heating
+ 5. Fuel and exhaust systems
+ 6. System of decrease in toxicity
+ 7. Transmission
+ 8. Brake system
+ 9. Suspension brackets and steering
+ 10. Body
+ 11. Electric equipment
+ 12. Electrical circuitries

3.2.14. Details of a suspension bracket and engine

GENERAL INFORMATION

Engine mount details as a rule do not demand leaving, however, at detection of damage of support of the engine, or aging signs, they should be replaced immediately.

Check

PERFORMANCE ORDER

1. Lift the car and establish on supports, then place a support under the oil pallet of the engine. Lay a big board between the pallet and a support and carefully raise the engine to unload support. It is forbidden to substitute a board under a drain stopper of the pallet.

2. Check existence on support of cracks, hardenings or peelings from a metal basis (the left support – a photo at the left, the right support – a photo on the right).
3. Check whether plates of support concerning the engine move (for this purpose shake support mount, or the big screw-driver). If movement is felt, then lower the engine and delay fastenings of support.
4. For delay of aging grease rubber details of support with the preserving means.

Replacement

PERFORMANCE ORDER

1. Disconnect the battery from weight, lift the car and establish on supports.

2. For removal of the right support turn off from below nuts and 1 bolt from above, remove the top section of a support from an engine arm.

3. Turn off nuts of fastening of a support to the chassis and remove a support.

4. For removal of the left support turn off a nut and a bolt, separate the lower and top support.

5. Turn off bolts of pillows of support on the block of cylinders and the chassis, remove support.

6. Installation is carried out upside-down. Grease carvings of nuts and bolts with the fixing structure and reliably tighten.